Is it possible to use the rCell to communicate directly to the radio via serial port?

Yes, it is possible to use the rCell to communicate directly to the radio via serial port.

1. Go to PPP page and disable the following:

a. NAT.

b. PPP.

Click on Submit button.


2. Then go to SERIAL PORT page:

a. Client Settings -> Enable.

b. Client type -> TCP.

c. Primary Server: Set to the IP address of the rcell's Ethernet. 192.168.2.1

d. Port: 5000.

e. Connection Start by: Always on.

f. Connection Terminate by: Others -> Always on.

Click on Submit button.


3. Go to IP page:

a. Auto dial out -> Enable.

b. Raw dial out -> Enable. <--This must enable other wise it will not work.

c. Auto dialout login -> Disable/Enable. It does not matter. You will get login prompt.

d. Auto dial out port: 5000.

e. Handle EIA signal: Disable.

Click on Submit.

Then do save and restart.

The terminal software should set to: 115200 8N1 and no flow control.