I have a Multitech RF660VPN which I have set-up to allow PPTP access. I would like to authenticate against a Steel Belted Radius for Netware server which does the authentication for my other remote access servers.

ADDITIONAL INFORMATION:

At the moment, the request reaches the Radius server but is then rejected. This works fine if I use local users in the RF660. What checklist and returnlist attributes are required on the Radius server for this to work properly.


RESPONSE:

Your Radius server needs to support the MPPE attribute. Here is an example of our Radius server user file:

Service-Type = Framed-User,
Vendor-Specific = MPPE_ALLOWED
Framed-Protocol = PPP,
Framed-IP-Address = 255.255.255.254,
Framed-Routing = None,
Framed-MTU = 1534,
Framed-Compression = Van-Jacobson-TCP-IP