I am in the process of moving a data center and need to change the IP addresses for the MultiModemManager via hyperterminal, how can I do this?

When Logged into the MR4800E controller (MMM), from the a:\# prompt, issue the command "whoami". To change the IP address of the controller You need to be logged in with supervisor access rights.

Issue the following commands, after making a change, type the "boot" command to reboot the controller for the change to take effect.

To identify current settings:

getip
getsubnet
getgateway

To change a setting issue:

setip ###.###.###.###
setsubnet ###.### ###.###
setgateway ###.### ###.###

You can also bring up a menu driven setup utility by typing the command SE (this Set Environment utility is what runs automatically for new out of box units).